31
Jan
Jan
SuperSlicer profiles for Artist-D
11
May
May
Start GCode suitable for Artist-D pro or Standard. This puts the printer into duplication mode and prints purge lines with each extruder. Here is the code for Mirror Mode Here is the Start GCode for Single Extruder Mode
Physical Printer Check check wiring, nothing should be loose Ribbon cables should be firmly set or they will burn up. purge cups should not interfere with carriage motion Leveling don’t mess with E2 leveling until E1 is perfect. Remember leveling on this printer is center first, leveled with z stop ** then level corners with […]
